Instruction manual

26
6 DSC OPERATION
New2001
DD
Transmitting a Group call
The Group call function allows you to transmit a DSC signal
to a specific group only.
q Enter “
GGrroouupp CCaallll
” in DSC menu.
w Rotate [SELECTOR] to select the desired pre-pro-
grammed group address or “
MMaannuuaall IInnppuutt
,” push
[ENT].
• The ID code for the Group call can be set in advance. (p. 17)
• When “
MMaannuuaall IInnppuutt
” is selected, set the 8-digit ID code
for the group you wish to call with keypad.
e Rotate [SELECTOR] to select a desired intership channel
or “
MMaannuuaall IInnppuutt
,” push [ENT].
• Intership channels are already preset into the transceiver in rec-
ommending order.
r Push [ENT] to transmit the Group call.
• If Channel 70 is busy, the transceiver stands by until the channel
becomes clear.
t After the Group call has been transmitted, the following in-
dication is displayed.
y Push [CLR] to exit and the transceiver selects the inter-
ship channel specified in step e automatically.
• Even if [CLR] hasn’t been pushed, the transceiver selects the
specified intership channel in step e automatically after 2 sec. of
inactivity.
Group Call
TX Complete
<CLR˘Exit>
--DSC Menu--
Select Intership CH
˘08
69
77
06 ≥
<CLR˘Exit / ENT˘OK>
--DSC Menu--
Group Call Ready
<CLR˘Exit / ENT˘OK>
--DSC Menu--
Select Address
Manual Input
˘Icom
Coast station
<CLR˘Exit / ENT˘OK>

DDSSCC MMeennuu
➪
GGrroouupp CCaallll

(Push [MENU]) (Rotate [SELECTOR], then push [ENT].)
IC-M604-1.qxd 06.7.20 5:55 PM Page 26 (1,1)