Instruction manual

40
7 OTHER FUNCTIONS
New2001
t After releasing [PTT] you can hear the response through
the speaker.
y To return to normal operation, push [CLR] or repeat step
q.
• While in the intercom mode, the transceiver functions
(transmit and receive) are interrupted. If the transceiver
is in transmit condition, the intercom function is not avail-
able.
• When a DSC call is received, the intercom function is in-
terrupted with an automatic return to the transceiver
mode. The transceiver’s display indicates ‘Receiving DSC
calls.’ (p. 32)
• When a WX alert is received, “
WWXX AALLEERRTT
” blinks and a
beep sounds. The WX alert sounds after the Intercom
use is finished.
■ Hailer operation
The IC-M604 has a 2-way hailer function for voice amplifica-
tion and reception over a loudspeaker, making it unnecessary
to leave the bridge to hear a hailing party. During hailer oper-
ation, transmitting is impossible and the received signal is
muted.
Connect an external hailer speaker as described on p. 46.
q Push [F], then push [7• ] to enter hailer mode.
w Push and hold [PTT] and speak at a normal voice level
into the microphone.
•“
TTAALLKK
” or “
LLIISSTTEENN
” appears on the caller or listener function
display, respectivery.
• To adjust the hailer level, rotate [SELECTOR].
e After releasing [PTT] you can hear the response through
the speaker.
r To return to normal operation, push [CLR] or repeat step q.
• While in the hailer mode, the transceiver functions (trans-
mit and receive) are interrupted. If the transceiver is in
transmit condition, the hailer function is not available.
• When a DSC call is received, the hailer function is inter-
rupted with an automatic return to the transceiver mode. The
transceiver’s display indicates ‘Receiving DSC calls.’ (p 32)
HAILERHAILER
LISTENLISTEN
1515
then push
Push ,
HAIL
IC-M604-1.qxd 06.7.20 5:55 PM Page 40 (1,1)