Instruction manual

43
8
SET MODE
7
8
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: Scan type, Scan resume timer, Weather
alert, Beep tone, Internal speaker, LCD contrast, Attenuation
level, Automatic foghorn frequency, Radio power*
1
, Scram-
bler type*
2
, Scrambler code*
2
and Favorite channel.
*
1
Appears only when an optional COMMANDMIC™ is connected.
*
2
Appears only when an optional scrambler unit is installed.
Available functions may differ depending on dealer setting.
q While pushing and holding [!6•9], push [POWER] to enter
Set mode.
• Turn power OFF in advance.
w After the display appears, release [!6•9].
e Rotate [SELECTOR] to select the desired item, push [ENT].
r Rotate [SELECTOR] to select the desired condition of the
item, push [ENT] to set.
t Push [CLR], or rotate [SELECTOR] to select “
EExxiitt
” then
push [ENT] to exit Set mode and returns to normal condition.
■ Set mode items
DD
Scan type
The transceiver has 2 scan types: normal scan and priority
scan. Normal scan searches all TAG channels in the selected
channel group. Priority scan searches all TAG channels in se-
quence while monitoring Channel 16.
DD
Scan resume timer
The scan resume timer can be selected as a pause (OFF) or
timer scan (ON). When OFF is selected, the scan pauses
until the signal disappears. When ON is selected, the scan
pauses 5 sec. and resumes even if a signal has been re-
ceived on any other channel than Channel 16.
(Default: OFF)
--Set Mode--
Scan Timer
ON
˘OFF
(Default: Normal)
--Set Mode--
Scan Type
Priority
˘Normal
Rotate
• SET MODE CONSTRUCTION
--Set--Set Mode--Mode--
˘ScanScan TypeType
ScanScan TimerTimer
WXWX AlertAlert
BeepBeep
InternalInternal SpeakerSpeaker
ContrastContrast
RFRF AttenuatorAttenuator
FoghornFoghorn FrequencyFrequency
RadioRadio PowerPower
ScramblerScrambler TypeType
ScramblerScrambler CodeCode
FavoriteFavorite CHCH
ExitExit
IC-M604-1.qxd 06.7.20 5:55 PM Page 43 (1,1)