Instruction manual

CONNECTIONS AND MAINTENANCE

New2001

y DC POWER CONNECTOR

Connects the supplied DC power cable from this connector

to an external 13.8 V DC power source.

CAUTION: After connecting the DC power cable, cover

the connectors with a rubber vulcanising tape as shown

below, to prevent water seeping into the transceiver.

■ Fuse replacement

One fuse is installed in the supplied DC power cable. If a fuse

blows or the transceiver stops functioning, track down the

source of the problem, if possible, and replace the damaged

fuse with a new, rated one.

■ Supplied accessories

The following accessories are supplied

■ Antenna

A key element in the performance of any communication sys-

tem is an antenna. Ask your dealer about antennas and the

best place to mount them.

Mounting bracket For mounting bracket

Knob bolts

Screws (5×20)

Flat washers (M5)

Spring washers (M5)

Microphone hanger

and screws (3×16)

Microphone DC power cable

Warning sticker SpongesAccessory connectors

(3 pin, 6 pin)

Fuse rating: 10 A

Rubber vulcanizing

tape

IC-M604-1.qxd 06.7.20 5:55 PM Page 47 (1,1)