Installation Guide

Cordless Bamboo Roll-Up
Installation Instructions
Please read the instruction sheet carefully before installing your new blind.
Blind Installation:
1. Before installing, make sure blind is fully rolled up and secured. For easier installation, do not remove paper
wrap packaging ties until finished.
2. Mark location of bracket holes, please note: The hook side of brackets will grasp the front of the headrail.
For Ceiling and Inside mounts: Hook side of bracket should face towards you, see image A below.
For Wall and Outside mounts: Hook side of bracket should face down, see image B below.
Tip: Make sure your mounting brackets and/or mounting surface are level and the same distance from the
top of the window. For best accuracy, measure the distance with a tape measure.
3. Install Brackets: Drill 1/16” pilot holes at the hole marks first, then screw in brackets.
4. Attach the Blind for ceiling or inside mount: Insert front bevel of headrail into hook side of bracket, rotate back
of headrail upwards into the back of the bracket, each bracket will click once engaged. Push button located on
hook side of bracket will release front edge of headrail.
5. Attach the Blind for Wall or outside mount: Insert front bevel of headrail into hook side of bracket, rotate
back of headrail towards wall into lower portion of the bracket, each bracket will click once engaged.. Push
button located on hook side of bracket will release bottom edge of headrail.
Package Includes:
• One Roll-Up Blind
• Brackets
• Screws
Tools Needed:
• Tape Measure
• Drill
• 1/16” Drill Bit
• Screwdriver
• Pencil
Achim’s Family of Home Furnishings
www.achimonline.com
Brooklyn, NY 11215
V-10
**Inside Mount
Outside Mount
Wall Mount – No
Window Frame
**For Inside Mount, Window
Frame must have depth of at least
six inches for roll-up clearance.
QUESTIONS: Contact customer service at 1-800-54-ACHIM
Visit our website at www.achimonline.com
Ceiling Mount
Image A
Image B
Blind Tension Adjustment:
The Roll-Up Blind’s tension easily adjusts with right
and left adjustment knobs.
Rotate the left knob for desired tension, speed of
movement when raising and lowering.
Rotate the right knob for open position adjustment
if full retraction is not desired.
An even – slower speed tension helps to prevent
uneven retraction of the Blind onto the roller.