Installation Guide

STERLING TILES INSTALLATION INSTRUCTIONS

Easy Do-It-Yourself Installation!

IMPORTANT: Make sure the PATTERN number located on the side of this box is the same when using

two or more boxes. Before installing the tiles, store them at room temperature for at least a day.

1. Preparing the Surface

ALL floor surfaces MUST be dry, clean, smooth and level.

• Cement: Fill in all cracks and holes with a suitable latex filler and coat all areas with a

suitable latex sealer. Not to be installed on untreated cement.

• Wood: Make sure all planks or plywoods are securely nailed down. Counter-sink nail heads,

and cover with latex filler. The surface must be completely clean and free of paint, varnish,

or wax and completely seal all areas with a suitable latex sealer.

• Resilient Vinyl: Remove all dirt, grease, or wax build up.

Do NOT install tiles over cushioned vinyl rubber flooring. Remove flooring or cover with plywood.

If installing plywood, remember to countersink the nails and cover the holes with filler and then completely

seal with a suitable latex sealer.

DO NOT INSTALL TILES OVER:

• Any floor exposed to excessively hot or cold temperatures.

• Any floor exposed to excessive moisture.

• Radiant heated floors.

• Particle board or MDF Board.

2. To Begin:

You must determine the center point of your room. Measure the center points of opposite walls

and secure a chalk line from one to the other. Snap the line. Repeat the process with the other set

of opposite walls. The point at which the chalk lines intersect is the room's center. (Figure 1)

3. Tile Installation:

Wherever tiles are marked with arrows in the back, install them so that all arrows point in the same

direction. Starting at the center point as shown in Figure 1, peel off the protective paper and carefully

align the tile with the chalk line markings. Press down firmly. (Caution: the tile’s protective paper covering

is very slippery. To avoid accidents, do not leave the paper on the floor after you've peeled it from the

PAGE 1
STERLING TILES INSTALLATION INSTRUCTIONS Easy Do-It-Yourself Installation! IMPORTANT: Make sure the PATTERN number located on the side of this box is the same when using two or more boxes. Before installing the tiles, store them at room temperature for at least a day. 1. Preparing the Surface ALL floor surfaces MUST be dry, clean, smooth and level. • Cement: Fill in all cracks and holes with a suitable latex filler and coat all areas with a suitable latex sealer. Not to be installed on untreated cement.
PAGE 2
tile.) Moving along the chalk line, abut each tile squarely and as tightly as possible. Without going directly against the wall initially, form an “L” shape as shown in Figure 2. Cover a quarter of the surface area at a time. Do not install tiles to the edges of the room until the main floor area has been covered. 4. Cutting Tiles: Tiles should be cut with a straight edge and utility knife. (Do not cut over newly installed tiles as the blade may damage the new tiles.) Cut edges should face the wall.