Owner manual

5
Inputs and Outputs
CV In:
Input for connection to a 1V/octave source (Autobot, Bassline3, sequencer, Midi-to-
CV-Interface,…). The CV In converts 1V/octave to the pitch.
Slide In:
Input for a 5-12 Volt gate input signal. The gate will hold the gate and the slide circuit
open for the duration of the gate is high. The Slide In works as Gate In too.
VCO CV In:
Input for linear VCO frequency modulation.
VCF In:
Input to the VCF for external audio signals.
The connected input signal will disconnect the VCO output.
Gate In:
Input to trigger the envelope generator and to gate the VCA.
Accent In:
Input for the Accent circuit and needs a 5-12 Volt signal to controll the accent-length.
The Accent In is normally controlled with the Accent Out of a Bassline3 or Autobot.
VCO Out:
Output of the VCO output signal. Saw or 303-Square is selected with the waveform-
switch.
VCF CV In:
Input for VCF frequency modulation. If no signal is connected, the internal signal Saw
of the VCO is wired to this input.
VCA In:
Input to the VCA for external audio signals.
The connected input signal will be mixed with the VCF output signal.
Env Out:
This is the output of the envelope signal.
Audio Out:
This is the audio output of the M303 modular bass-synthesizer.