Owner's Manual

12
FP function
LOCK function
2s
Keep pressing Fan button for more than 2 seconds to activate/disable Silence
function(some units).
Due to low frequency operation of compressor, it may result in insufficient cooling
and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean button while
operating will cancel silence function.
Silence function
5s
5s
Turbo
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8 C/46 F.
Note: This function is for heat pump air conditioner only.
2
+
Press together Turbo button and Humidity button at the
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
Turbo Function
Press Turbo button
Turbo
When you select Boost feature in COOL mode,
the unit will blow cool air with strongest wind setting to
jump-start the cooling process.
When you select Boost feature in HEAT mode,
for units with Electric heat elements, the Electric HEATER
will activate and jump-start the heating process.
O O
O O
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F or 20 C/68 F(for models RG10L10(G2HS)/BGEF & RG10L10(D2HS)/BGEF only).
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F or 20 C/68 F(for model RG10L10(G2HS)/BGEF& RG10L10(D2HS)/BGEF) to
activate FP function.Press On/Off, Sleep, Mode, Fan and Temp. button while operating will
cancel this function.
Humidity