Owner's Manual

13
SET function
SET
OK
Active clean function( ) (some units) :
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
Breeze away ( ) Active clean/Self clean ( ) Fresh ( ) Sleep( ) Follow Me( )
AP mode ( ) Breeze away....
[ ]: Model dependent


 


*
*
*
*
The Active Clean Technology washes away dust,
mold, and grease that may cause odors when it
adheres to the heat exchanger by automatically
freezing and then rapidly thawing the frost.
When this function is turned on, the indoor unit
display window appears “CL”, after 20 to 45
minutes, the unit will turn off automatically and
cancel CLEAN function.
This feature avoids direct air flow blowing on the
body and makes you feel indulging in silky
coolness.
NTOE: This feature is available under cool,
Fan and Dry mode only.
Breeze Away function( ) (some units) :
Intelligent Eye Function(For models of RG10P series)
Press this button
Under Intelligent eye mode, with the built-in infrared sensor, the unit
can detect
the people’s activities in the room. The wind can flow away from
people, but also can follow people.In Cooling mode ,when you are away for 30
minutes, the unit automatically lowers the frequency to save energy(for inverter
models only).
And the unit will automatically resume operation if sensing
human activity again.
For details, please see “ Intelligent Eye operation ” in “Owner’s Manual &
Installation Manual” .