Owner's Manual

Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions section of this manual.
ON/OFF
Turns the unit on or off.
MODE
OK
TIMER
Eco Intelligent eye
HUMIDITY
LED
Turbo
ECO/GEAR
Scrolls through operation modes
as follows:
AUTO  COOL 
DRY 
HEAT  FAN
FAN SPEED
SWING
Model:
Increases temperate in
0.5°C (1°F) increments.
Max. temperature is
30°C (86°F).
NOTE: Press together &
buttons at the same time
for 3 seconds will alternate
the temperature display
between the °C & °F.
TEMP
TEMP
04
RG10L(G2HS)/BGEF and RG10L(G2HS)/BGEFU1(Fresh feature is not available)
RG10L1(G2HS)/BGEF,RG10L1(G2HS)/BGEFU1
RG10L10(G2HS)/BGEF(20-28 C/68-82 F)
Used to confirm the selected functions.
Used to detect the people
activities in the room to save
energy.
Decreases temperature
in 0.5 C(1 F) increments.
O
O
Min. temperature is
O
O O
O
16 C(60 F).
T
urns indoor unit’s LED display
and air conditioner buzzer on
and off, which create a comfortable
and quiet environment.
Adjust the room humidity during
Dry operation in a range of
35%~85%. Press this button to
increase the humidity in 5%
increments.
NOTE: After setting, the humidity
settings will display on the screen.
Set timer to turn unit on or off
Press this button to enter the
energy efficient mode in a
sequence of following:
ECO GEAR(75%)
GEAR(50%)
mode ECO
......
Selects fan speeds in the
following order:
AU


20%
60% 40% 80% 100%.



Press the TEMP or button
to increase/decrease the fan
speed in 1% increments.
Enables unit to reach preset
temperature in shortest possible time.
Previous setting
SET
Scrolls through operation
functions as follows:
Breeze away( )
clean( ) Fresh( )
Sleep( )
Follow Me( )
AP mode ( ) Breeze
Active






The selected symbol will
flash on the display area,
press the OK button to
confirm.
away( ) .......
Starts and stops the horizontal
louver movement. Hold down
for 2 seconds to initiate vertical
louver auto swing feature.
NOTE: HEAT mode is not supported
by the cooling only appliance.