Installation Instructions

(viii) If you would like the Node to immediately send a reading to the Gateway, please press
the “TEST” button on the device physical circuit board.
(ix) For additional node commissioning, repeat the steps above.
(x) You can now go to the Gateway software dashboard on your computer and click on your
project. You will now be able to see your commissioned devices under “Device Summary”
Section.
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
2. This equipment complies with RF radiation exposure limits set forth for
an uncontrolled environment.
3.This equipment should be installed and operated with minimum distance 20cm between
the radiator& your body.