User manual

43
3
Mehr als nur Telefonieren
3
More than only telephone calls
Switching lights, heating, alarm system ...
It is not only possible to connect telephones, fax devices etc. to the EURACOM, but
also control equipment for lights, heatings, alarm systems ... These can then be
switched on and off from an internal or external telephone via control contacts of the
EURACOM.
In configuration the control contacts are programmed for manual switching
(--> “Configuration”, page 65).
Furthermore remote control is activated and a virtual subscriber established for
switching via an external telephone. A remote control PIN is programmed for the
virtual subscriber (--> “Configuration”, page 86).
If you want to operate the control contacts from an internal telephone, this must
have a
master authorization or company authorization.
If you want to operate the control contacts from remote, you need a telephone or
hand transmitter with tone dialling for entry.
Operating control contacts from an internal telephone
+
#*059
eg 1 1 or 2: number of the control contact, the lights,
heating ... is switched to.
In case of the EURACOM 141F, 141 with installed
MST module always the 1. In case of the other
PABXs read the configuration via the PC (actors)
or consult your distributor.
eg 00 switching off lights, heating ...
1 switching on lights, heating ...
#
- You have now switched on or off the lights, heating ...
Operating control contacts from an external telephone
+
number The number of the virtual subscriber (PABX
telephone number + dial-in or multiple
subscriber number). After 10 seconds you will hear
the special dialling tone for a short time. Continue
with the input afterwards rapidly.
2 PIN * PIN = personal identification number of the virtual
subscriber. Now operate the control contacts in the
same way as from an internal telephone (see
above).