Owner`s manual

P5000 Series Owners Manual 12/16/04 5:16 PM Page 5

II. Sensor Installation

Locate sensors below

Sensors need to be mounted below the bumper. To protect the rear corner

of the vehicle, mount sensors within 1' from the edge. Place the sensors

at the desired locations and mark drill holes with a felt tip marker. Prior

to drilling, check the underside of the bumper to be certain that there

are no wires or items that may be damaged by the drill bit. Drill using

a 5/32" size bit. Screw sensor onto bumper.

Each sensor comes with a flexible transducer, whose surface has a sensor-

angle-adjustment screw. By loosing the screw, adjust transducer angle

and then lock it to select a proper angle if the mounting position would

otherwise be too low.

NOTE:

The driver's side is considered the left side of the vehicle.

The sensors are marked:

R=Right, CR=Center Right, CL=Center Left, L=Left