Owner`s manual

6
P5000 Series Owners Manual 12/16/04 5:16 PM Page 6
III. Control Box, Wireless Transmitter & Display
Installation:
Before assembly, install Control Box in a area that loose fit the water
resistant control module in a location that minimizes physical damage,
away from extreme heat and severe water ingress.
Loose the taper from base of transmitter, then knob antenna to the base
and fix it with taper to assemble transmitter. Drill using a 5/32" size bit,
then fix the transmitter beside control box with screw around the corner.
Begin by parking on a flat level surface, set brake and disconnect ground
wire from battery. Measure the length of the bumper and mark the center
point with a mark on masking tape. Divide the bumper as shown below.
To protect the rear corner of the vehicle, mount sensors within 1' from
the bumper ends.