Owner`s manual

7
P5000 Series Owners Manual 12/16/04 5:16 PM Page 7
Attach sensor cable extensions and cable tie the sensor cables to conceal.
Be certain the cables will reach the control module then fasten the control
module using the screws provided. Attach the sensor cables to the control
module. Be sure to match the correct sensor location with the module inputs.
Clean the display location with alcohol and attach display to dash.
(Wireless Display) Loose the screw at the base of display, then insert display
sphere to base and fix the screw to assemble display. Splice red (+) power
lead into a keyed circuit or run to fuse box. Splice or attach black (-) ground
wire to sufficient ground. Clean the display location with alcohol and attach
display to dash. Cable tie power cable and conceal.
Identify the power wire to the reverse lights using a test light. Connect the
Red positive wire from the control box to the reverse lights positive lead,
and the Black ground wire to the reverse light's ground or other ground
using the splice connectors supplied. Electrical tape or shrink-wrap the
splices for additional protection.
IV. System Check:
A. Re-connect battery
B. Engage brake, turn the ignition on
C. Shift transmission into reverse and make certain reverse lights are on.
Two beeps from the display indicate the system is active.
D. Note detection patterns and alerts levels below.
2-4F
0-2F
4-6F
0-2F
2-4F
4-6F
6-10F