CH 1 GATE MIX CH 2 CH 3 CH 4 GATE MIX GATE IN User’s Manual Eurorack Synthesizer Modules 1 2 1 2 AUX 1&2 IN MIX 3 4 3 4 3&4 SUM 12 HP
TABLE OF CONTENTS 1.INTRODUCTION 2.WARRANTY 3.INSTALLATION 4.FUNCTION OF PANEL COMPONENTS 5.
1. INTRODUCTION Audiophile Circuits League. -GATE MIX is a 4 channel Audio signal mixer, consisting two 2-in-1 mixers (1+2 & 3+4), whose outputs are summed together to the master output. All 4 channels can be switched ON/OFF controlled by switches and/or gate or even CV signals. Further there is an AUX-input, which is routed unity gain (no attenuator) to the SUM.
2. WARRANTY Is it a malfunction? In the event of a fault in use, we will repair or replace it free of charge under the warranty terms stated below. The warranty period is valid for one year from the Please read the user's manual carefully and check again. If you think that there is day of purchase. If repair is necessary, please ask the dealer you purchased it still a problem, please consult the dealer you purchased from or contact us from. (English) .
3. INSTALLATION ⚠WARNING *Always turn the Eurorack unit off and unplug the power cord before pluging GATE the Eurorack power cable. CV *When attaching the Eurorack power cable, please be careful not to touch the +5V terminal part. +12V GND Connect to the Eurorack's system power supply (+ 12V) using the supplied GND Eurorack power cable. Connect the 16-pin connector to the Eurorack power connector.
4. FUNCTION OF PANEL COMPONENTS ① "CH1~4" knob GATE MIX Adjust the Inputs for 4 audio signals, attenuated by potentiometers for every channel . 1 ② "GATE IN" switch All input channels can be individually switched on / off by switches or positive GATE · CV signals. In addition, logic can be reversed, such as channel on with a positive CV signal and channel off with a positive CV signal on the other hand. GATE IN 2 ③ "GATE IN" jacks Input the CV signal for turning on / off each channel.
⑧ "ALL" output jack Output jack for summed all of channels 1 - 4 and AUX.
5.
