Variable Sync VCO User’s Manual Eurorack Synthesizer Modules 16 HP
TABLE OF CONTENTS 1.INTRODUCTION 2.WARRANTY 3.INSTALLATION 4.FUNCTION OF PANEL COMPONENTS 5.
1. INTRODUCTION Audiophile Circuits League. -Variable Sync VCO module consists of one ramp core oscillator with several wave shaper subcircuits, all having that classical vintage tone, loved by a lot of musicians and soundsynthesists. The VCO is capable of delivering that without sacri�icing tracking precision and low temperature drift. Available waveshapes are saw, inverted saw, triangle, sine and PW rectangle, which uses the saw wave from the waveshaper as a carrier for the PWM.
2. WARRANTY Is it a malfunction? In the event of a fault in use, we will repair or replace it free of charge under the warranty terms stated below. The warranty period is valid for one year from the Please read the user's manual carefully and check again. If you think that there is day of purchase. If repair is necessary, please ask the dealer you purchased it still a problem, please consult the dealer you purchased from or contact us from. (English) .
3. INSTALLATION ⚠WARNING *Always turn the Eurorack unit off and unplug the power cord before pluging GATE the Eurorack power cable. CV *When attaching the Eurorack power cable, please be careful not to touch the +5V terminal part. +12V GND Connect to the Eurorack's system power supply (+ 12V) using the supplied GND Eurorack power cable. Connect the 16-pin connector to the Eurorack power connector.
4. FUNCTION OF PANEL COMPONENTS ① "TUNE" dial Fine tune with 10 turn precision pot approximately 4&1/2 octaves. 5 1 ② "FREQ" selector Three frequency ranges – with a little bit more than 2 octaves apart. 2 3 ③ "EXP FM 1&2" knob 4 1V /OCT. 7 6 10 15 Two independent exponential type attenuators for CV signal input from 9 8 11 16 12 17 ④ "FM1&2" jacks. When fully open the knob clockwise, it works the same as 13 18 ④ "FM 1&2" input jacks They are CV signal input jacks.
⑦ "SYNC CV" knob ⑭ "PWM" input jack ⑧ "PW" knob ⑮ "Saw Wave" output jack ⑨ "PWM CV" knob ⑯ "Inverted Saw Wave" output jack ⑩ "1V/OCT" input jack ⑰ "Triangle Wave" output jack ⑪ "SYNC" input jack ⑱ "Sine Wave" output jack It is an attenuverter for the CV signal to control the "THRESHOLD" of the sync This is an input jack for controlling Pulse Width Modulation (PWM) with a CV type. Input a CV signal from the ⑫ "SYNC CV" input jack. signal. ⑨ "PWM CV" knob is an attenuator.
5. SPECIFICATIONS Power Eurorack system power supply Width 16 HP Depth 22 mm Power consumption Ca. 35mA on -12V / ca.