User's Manual

DRAFT
32 TWACS
®
- ORION
®
for CENTRON
®
Meter User Guide
Troubleshooting and Error Messages
15. Press the down arrow or the Enter button
Ignore this screen for installation purposes.
16. Press the down arrow or the Enter button
The Acq Log displays 24 bits (in three groups of eight) representing
the hourly check-in for the last 24 hours. A one (1) indicates that the
hourly check-in was successful and a zero (0) indicates that it was
not. The least significant bit (bottom right) indicates the past hour
check-in status. Each hour the bits are shifted one position to the
left. In the example below, the ORION successfully checked in the
past hour, but did not for each of the previous three hours.
17. Press the On/Off button to turn the HHTR-LP Off.
HHTR-LP Displayed Error Codes
The following table lists the error code number and error message text that
the HHTR-LP displays when the specific error is encountered while using
the HHTR-LP to communicate with the TWACS-ORION system.
Orion Com Status
Lnk Abandonment: N/A
RF Link Data:
Error Code: N/A
Orion Com Status
RF Link Data: 24 Hr
Acq Log:
00000000 00000000
00000000
Acq Log: 11111111
11111101 11110001
Table 2.1 Error Code Description and Solution
Error Description Solution
The following error codes are RF communication errors.
01 RF Error General error. Retry the command.
02 Service Not Supported Service is not supported. Retry the command.
03 Not used
04 Operation Not Possible RF error. Retry the command.
05 Inappropriate Action
Requested
RF error. Retry the command.
06 RF Device Busy RF error. Retry the command.
07 Data From Device Not
Ready
RF error. (Usually memory) Retry the command.
31 RF Device Sent NAK RF error Retry the command.