User's Manual

DRAFT
TWACS
®
- ORION
®
for CENTRON
®
Meter User Guide 33
Chapter 2 • Testing, Troubleshooting, and Maintenance
32 Can not acquire an RF Link RF error Retry the command.
33 Operation Timed Out Operation time expired without
success.
Retry the command.
The following error codes are internal HHTR-LP or user
errors.
101 RF PIC sends a NAK The RFPIC isn't ready or doesn't
understand the command. The RF
PIC internal to the HHTR-LP has
failed.
Retry the command.
102 RF PIC is busy RFPIC is performing another
operation and is currently busy.
The RF PIC internal to the
HHTR-LP was in the middle of
another command.
Retry the command.
103 No response from RF PIC
on HHTR-LP
The RFPIC isn't responding to the
UI. No Response from the RF
PIC. The RF PIC didn't respond
to the UI processor.
Retry the command.
104 RF PIC send invalid
response
The RFPIC sent an invalid
response to the UI. The
HHTR-LP UI processor didn't
recognize the response from the
RF PIC.
Retry the command.
105 Operation canceled Indicates the Esc button was
pressed during an operation.
The user aborted the last
command.
106 ORION-EMTR session
failed
The HHTR-LP timed out waiting
for the RMTR to respond back to
the HHTR-LP.The HHTR-LP
was unable to link to the
requested EMTR-2.
Verify the serial number
and retry the command.
107 No Space Available in
EMTR. The Table is Full.
The EMTR is at capacity. It can
not accept additional Remotess.
A Remote must be
removed before adding
another.
112 EMTR already has
Remotes assigned
Can not program a new EMTR
with the data from an old EMTR
because the new EMTR already
has Remotes assigned.
Remove all Remotes from
the new EMTR first.
113 The New EMTR can not
accept xx Number of
Remotes.
Can not program a new EMTR
with the data from an old EMTR
because the new EMTR can not
store as many Remote as the old
EMTR.
114 An order needs to be
created first. Use the order
menu
When replacing an EMTR, the
HHTR-LP needs to store the
Remt list. An “order number”
needs to be assigned so that the
HHTR-LP has a location to store
the list.
Select “order” from the
main menu, select “new”
and enter a number.
Table 2.1 Error Code Description and Solution
Error Description Solution