User's Manual

DRAFT
34 TWACS
®
- ORION
®
for CENTRON
®
Meter User Guide
Meter Shop Test System
If you are unable to resolve a problem with the TWACS-ORION system,
return the meter to your integrator or DCSI. See Return Procedures.
Refer to the Electronic Metering Transponder for CENTRON Meter User
Guide (Y10317TM) Rev. A for transponder-related troubleshooting
information.
Refer to the CENTRON Meter Technical Reference Guide for additional
meter information.
Meter Shop Test System
Use the Meter Shop Test System to test TWACS signaling, read select
transponder registers, zero select transponder registers, and perform
various other transponder functions on a TWACS-enabled CENTRON
meter. For complete details on the Meter Shop Test System, see the Meter
Shop Test System Help (accessed by clicking the Help button on the Meter
Shop Test Tool main menu) or contact your Program Manager or DCSI
Customer Care at [e-mail] or 1-800-892-9008.
Because of the various test equipments available for use with DCSI
products and the configuration requirements/options, the Meter Shop Test
System Set-Up Guide (Y10030TM), will guide you through initial
equipment selection and setup for meter/module testing.
This user guide contains all the module-specific information necessary to
test the RF TWACS-ORION System installed in the CENTRON meter.
EMT-3C module TWACS serial number and meter-specific information is
available on the meter label. Refer to Figure 2.1. Additional information,
such as module Type and Model, can be found in Chapter 1 of this user
guide.
If you are unable to resolve a problem with the TWACS-ORION System,
return the meter to your integrator or DCSI. See Return Proceduresbelow.
208 ORION S/N Already
exists in the EMTR Table.
Can not install the selected
ORION because it is already
installed.
209 The Selected ORION is
NOT in the EMTR Table.
Can not remove the ORION nor
perform a Com Status because
that ORION is not installed to the
selected EMTR.
Check serial number and
try again.
211 Service is Full, Can not
add ORION to the EMTR
List.
This service in the EMTR is at
capacity. It can not accept
additional Orions.
An ORION must be
removed from this service
before adding another.
215 The Selected Remt. is
NOT an Orion.
Table 2.1 Error Code Description and Solution
Error Description Solution