Installation Instructions

MTU Instruction
for Rockwell/Equimeter Commercial Gas Meters
Step 7 – Place the pulser on the meter,
aligning the lower coupler so that it will
engage the fork portion of the meter drive
foot as shown below.
Ensure that the pulser body sits properly
on the gasket and that the wire is routed
through the wire exit notch.
Step 8 – Next, place the upper gasket on
top of the pulser as shown in the
illustration below.
Step 9 – Mount the index onto the pulser
using the 5/16 -18 x 2 1/4” slotted fillister
head bolts provided, as shown in the
illustration below. Ensure that the drive
foot on the index engages with the slot in
the top of the tall coupler.
Page 116