Installation Instructions

MTU Instruction
for Rockwell/Equimeter/Sensus Gas Meters
Step 3 – Position the register on the front
of the sensor assembly, aligning the drive
gear with the index drive. Mount the
index to the sensor assembly using the
two #6 x 3/4” screws provided.
Step 4 – Carefully remove the protective
cap from the drive coupler on the rear of
the sensor assembly. Note the tooth on
the inner surface of the coupler.
Step 5 - Position the sensor on the meter.
so that the tooth on the coupler engages
with the teeth on meter’s index drive gear.
If engaged correctly, the cork gasket on
the sensor will fit flush against the surface
of the index box.
Page 164