Installation Instructions

MTU Instruction
for DFW Rectangular Composite Pit Lids
Be sure to position the MTU as shown,
with the top (antenna) section of the MTU
positioned in the approximate center of
the lid.
Torque screws to approximately 8 in-lbs.
The MTU should be snug and suspended
by the spacers above the bottom surface
of the pit lid by approximately ½”.
CAUTION!
Be sure to follow all General
Guidelines outlined in
Publication 471-2000 along
with the specific wiring
instructions for the meter
being used.
Step 3 – Wire the MTU to the meter,
making sure that the wire is routed so that
it does not become pinched when the lid
is closed.
Step 4 - Installation is now complete. You
can now proceed to program the MTU
using the STAR Programmer Software
and your MTU Programmer.
Template
Page 173