Installation Instructions

MTU Instruction
for Mid-States 12" Round Pit Lids
Installation Procedure
Step 1 – Place the pit lid top-side down
on a solid surface, positioning the metal
latch nearest to you as shown in the
photo below.
Step 2 – Pre-assemble the MTU, spacers
and bracket as shown below, using the
two #10-32 x 1-3/4” machine screws
through the back of the MTU mounting
tabs and spacers. Thread the bracket
onto the screw at the left side of the MTU
Step 3 – Turn the MTU face down onto
the bottom surface of the pit lid
positioning it as shown below. Align the
slot in the bracket with the mounting post
at the top right and insert the #10-32 x ½”
machine screw. Then tighten all hardware
to approximately 8 in-lbs.
Step 4 – Here’s another view of the
finished assembly. Note the position of
the bracket.
Page 184