Installation Instructions

MTU Instruction
for Actaris/Sprague/Schlumberger Gas Meters
Step 8 – Next, thread alignment studs
into the threaded mounting holes on the
left and right side of the adaptor, as
shown below.
Step 9 – Next, slide the MTU over the
alignment studs, positioning the coupler
on the MTU to ensure that it engages
correctly with the wiggler on the gas
meter.
Step 10 – Now, slide the clear register
cover over the alignment studs while you
hold the MTU in position with your free
hand.
Step 11 - Next, insert one of the #10-24 x
2” screws through the top-center hole on
the clear register cover. Tighten this
screw just sufficiently to hold the MTU
and register cover to the meter.
Page 192