Installation Instructions

MTU Instruction
for STAR Submetering MTUs with Pulse Adapters
Step 3 - A screen asking if the operator
wishes to change the Psion’s serial
number is displayed.
NOTE: - At midnight, the software
automatically resets to require re-entry of
the log-on information. This is a security
measure in case the Psion is lost or
stolen.
Step 5 - The “Set Time & Date” screen is
displayed.
This number should match the last four
digits of the serial number etched on the
back of the Psion. Typically, select
N to
accept the serial number as is. Pressing
Y
will take the operator to a screen where
the serial number can be changed, if
necessary.
Step 4 – You are now at the logon
screen.
Log on by entering the following
information:
a - Operator: The Psion operator file
will accommodate up to 99 separate
operator user codes. This user code is
“Install” followed by an assigned
operator code. Enter your assigned
code number immediately after “Install”
without any spaces. Press Enter when
finished. Example: Install6
b - Enter the password. This password
will typically be assigned by a project
manager. Press
Enter when finished.
Example:
Acme
Note: Use the DEL key to backspace and
make corrections.
Make any corrections to the time and
date as required. Press Enter when
finished. It is not necessary to reset the
time if it is less than 5 minutes off.
Step 6 - The main menu of the STAR
software is now displayed.
At the top of the screen the installer
identification is displayed. The bottom of
the screen has instructions for navigation.
Most of the screens in the STAR software
have this instruction feature at the bottom
of the screen. The menu consists of
options you can select, as described in
the following table. The actual options
you see will depend on the configuration
of your system. Some choices may not
be available on your system.
Page 48