User's Manual

MTU Instruction
for Armorcast Composite Pit Lids
Step 7 - Installation is now complete. You
can now pr
using the S
and your MTU Programmer.
Step 3 – Use a hammer to gently tap
anchors into the holes indicated in the
previous photo.
Step 4 – Position the MTU face-down on
the bottom surface of the pit lid as shown
below. Insure that cable exit from the
MTU faces the rim of the lid.
Step 5 - Place plastic spacers under the
mounting lugs on the MTU as shown
below. Position the spacers so that the
notched ends mate up with the mounting
tabs on the MTU. Note that the spacers
lid
oceed to program the MTU
TAR Programmer Software
CAUTION!
Be sure to follow all General
Guidelines outlined in
Publication 471-2000 along
with the specific wiring
instructions for the meter
being used.
Mounting o
an Armorc
Step 1 – Place the pit lid top down on a
solid surfac
Step 2 – Note the pre drilled mounting
holes on the bottom of the pit lid. The
holes used for mounting an New Flatpak
STAR MTU are highlighted in the photo
below.
a New Flatpak STAR MTU t
ast pit lid.
e.
should provide a gap of approximately
3/8” between the bottom surface of the
and the top surface of the MTU.
Step 6 - Place 2 #8 x 2 ½” galvanized
sheet metal screws through the mounting
holes and the spacers, and guide the
screws into the anchors.
Step 7 – Torque screws to approximately
8 in-lbs. MTU should be snug to the
surface of the pit lid.
Step 8 – Wire the MTU to the meter,
making sure that the wire is routed so that
it does not become pinched when the lid
is closed.
Step 9 - Installation is now complete. You
and your MTU Programmer.
can now proceed to program the MTU
using the STAR Programmer Software
Page 143