User's Manual

MTU Instruction
for Rockwell/Equimeter/Sensus Gas Meters
Step 11 - After you feel engagement
between the index register gear and the
MTU coupler gear, tighten the register
screws until they are snug.
Step 12 - Place the new cover over the
register so that the top label or arrow is
on top and the vent holes are on the
bottom. Align the cover with the mounting
holes on the MTU, press it into place, and
insert the #10 x 1” screws. Hand tighten
to a torque not to exceed 3-5 inch-
pounds. The gasket should be
compressed slightly.
Step 13 - Replace any anti-tamper,
safety, or security hardware onto the p-
lastic cover as required.
Step 14 – Once Installation is complete,
program the MTU using the STAR
Programmer Software and your MTU
Programmer.
Page 18