User's Manual

MTU Instruction
for Armor Access Rubber Pit Lids
Installation Procedure
Mounting an Original Flatpak STAR
MTU to an Armor Access pit lid.
Step 1 – If there is a recess on the
bottom surface of the pit lid, place the
MTU into the recess. If no recess, center
the MTU as shown onto the inside
surface of the lid.
Pit Lid with No Recess
Pit Lid with Recess
Step 2 - Attach the MTU to the pit lid with
the 2” stainless sheet metal screws
through the recessed mounting holes as
shown. Torque screws to approximately 8
in-lbs. MTU should be snug and flush to
the surface of the pit lid.
Pit Lid with No Recess
Pit Lid with Recess
Step 3 – Wire the MTU to the meter,
making sure that the wire is routed so that
it does not become pinched when the lid
is closed.
Step 4 - Installation is now complete. You
can now proceed to program the MTU
using the STAR Programmer Software
and your MTU Programmer.
CAUTION!
Be sure to follow all General
Guidelines outlined in
Publication 471-2000 along
with the specific wiring
instructions for the meter
being used.
Page 38