User's Manual

MTU Instruction
for Armor Access Rubber Pit Lids
Mounting a New Flatpak STAR MTU to
an Armor Access pit lid.
Step 1 – Center the MTU as shown onto
the bottom surface of the pit lid. Place
plastic spacers under the mounting lugs
on the MTU as shown below. Be sure to
use the long spacers (Hexagram Part
Number 056-8150L).
Step 2 - Attach the MTU to the pit lid with
the 2 ½” stainless sheet metal screws
through the 2 mounting holes and the
spacers as shown. Torque screws to
approximately 8 in-lbs. The MTU should
be snug and suspended by the spacers
above the bottom surface of the pit lid by
approximately ½”.
Step 3 – Wire the MTU to the meter,
making sure that the wire is routed so that
it does not become pinched when the lid
is closed.
Step 4 - Installation is now complete. You
can now proceed to program the MTU
using the STAR Programmer Software
and your MTU Programmer.
Page 3
Page 39