User's Manual
Table Of Contents
- Table of Contents
- 471-2000.pdf
- 471-2001.pdf
- 471-2002.pdf
- 471-2003.pdf
- 471-2004.pdf
- 471-2005.pdf
- 471-2006.pdf
- 471-2007.pdf
- 471-2008.pdf
- 471-2009.pdf
- 471-2010.pdf
- 471-2011.pdf
- 471-2012.pdf
- 471-2013.pdf
- 471-2014.pdf
- 471-2015.pdf
- 471-2016.pdf
- 471-2017.pdf
- 471-2018.pdf
- 471-2019.pdf
- 471-2020.pdf
- 471-2021.pdf
- 471-2022.pdf
- 471-2023.pdf
- 471-2026.pdf
- 471-2027.pdf
- 471-2028.pdf
- 471-2029.pdf
- 471-2030.pdf
- 471-2031.pdf
- 471-2032.pdf
- 471-2033.pdf
- 471-2034.pdf
- 471-2035.pdf
- 471-2036.pdf
- 471-2037.pdf
- 471-2038.pdf
- 471-2040.pdf
- 471-2041.pdf
- 471-2042.pdf
- 471-2043.pdf
- 471-2044.pdf
- 471-2045.pdf
- 471-2046.pdf
- 471-2047.pdf
- 471-2051.pdf
- 471-2052.pdf
- 471-2053.pdf
- 471-2054.pdf
MTU Instruction
for Sprague Model 175 Gas Meters
Plastic Index with Metal Drive Foot
Step 7 – Route the sensor wire so that it
does not interfere with the magnet wheel
or the index gears. Hand tighten index
mounting screws. Gently move the 2-foot
hand to check for some free play to
insure that the register is not binding up.
Step 8 – Next, create an exit notch for the
sensor wire by cutting away a small piece
of the corner where the left hand edge of
the clear index cover meets the ridge at
the bottom of the meter head.
Step 9 – Secure the clear index cover to
the meter using the screw that originally
held it. Tighten the index cover screw.
Step 10 - Replace any anti-tamper,
safety, or security hardware onto the
clear index cover as required.
Bar Mounting the MTU
Step 1 - Thread the tie-wraps into the
MTU spacer as shown here.
Step 2 - Attach the spacer to the MTU
using the provided screws and washers.
Tighten the screws to 12 to 15 in-lb. On a
Page 98