User's Manual

MTU Instruction
for Sprague Model 175 Gas Meters
standard drill driver with 0 to 24 torque
settings, this is typically the #10 setting.
Step 3 - Wrap the tie wraps around the
bar as needed, pulling the ties around
(through the spacer plate) as they are
tightened.
Step 4 - Adjust the MTU as needed and
pull the tie wraps tight.
Step 5 - Trim off the excess tie wrap,
leaving about a ½” tab.
Step 6 – Once Installation is complete,
program the MTU using the STAR
Programmer Software and your MTU
Programmer.
Page 99