02053 AI

ASSEMBLY INSTRUCTIONS

MODEL: 02053 PAGE 1 OF 4

NOTE: THIS ITEM NOT RECOMMENDED FOR COMMERCIAL USE

KEEP THIS DOCUMENT FOR REFERENCE IN CASE PARTS ARE NEEDED

DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED!!

BED PARTS HARDWARE PARTS

№ DESCRIPTION QTY № DESCRIPTION QTY

Left Side Panel

1 PC 1

Hex-Head ￠1/4”*35mm Bolts

2 Pcs

Right Side Panel

1 PC 2

Hex-Head ￠1/4”*75mm Bolts

8 Pcs

Bottom Frame

1 PC 3

Hex-Head ￠1/4”*60mm Bolts

16 Pcs

Top Frame

1 PC 4

￠1/4” locked Nuts

10 Pcs

Guardrails

2 PCS

￠1/4”*20mm Nuts

8 Pcs

Supporting Leg

2 PCS

Curved Washers 24 Pcs

Metal Holder

2 PCS

Washers 12 Pcs

Allen Wrenches 1 Pc

Plastic pads 4 Pcs

Open wrench 1 Pc

PAGE 1
ASSEMBLY INSTRUCTIONS MODEL: 02053 PAGE 1 OF 4 NOTE: THIS ITEM NOT RECOMMENDED FOR COMMERCIAL USE KEEP THIS DOCUMENT FOR REFERENCE IN CASE PARTS ARE NEEDED DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED!! BED PARTS № A B DESCRIPTION Left Side Panel Right Side Panel C HARDWARE PARTS QTY № DESCRIPTION QTY 1 PC 1 Hex-Head ￠1/4”*35mm Bolts 2 Pcs 1 PC 2 Hex-Head ￠1/4”*75mm Bolts 8 Pcs 1 PC 3 Hex-Head ￠1/4”*60mm Bolts 16 Pcs 1 PC 4 ￠1/4” locked Nuts 10 Pcs 2 PCS 5 ￠1/4”*20mm Nuts 8
PAGE 2
ASSEMBLY INSTRUCTIONS MODEL: 02053 PAGE 2 OF 4 NOTE: THIS ITEM NOT RECOMMENDED FOR COMMERCIAL USE KEEP THIS DOCUMENT FOR REFERENCE IN CASE PARTS ARE NEEDED DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED!!
PAGE 3
ASSEMBLY INSTRUCTIONS MODEL: 02053 PAGE 3 OF 4 NOTE: THIS ITEM NOT RECOMMENDED FOR COMMERCIAL USE KEEP THIS DOCUMENT FOR REFERENCE IN CASE PARTS ARE NEEDED DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED!! Remark: 1. Please always keep the warning lable on the inside of the upper bed end structure permanently. 2.
PAGE 4
ASSEMBLY INSTRUCTIONS MODEL: 02053 PAGE 4 OF 4 NOTE: THIS ITEM NOT RECOMMENDED FOR COMMERCIAL USE KEEP THIS DOCUMENT FOR REFERENCE IN CASE PARTS ARE NEEDED DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED!! Size of Mattress This bed is designed to use a mattress 74” x 37-1/2” – 38-1/2” on the upper bunk and 74” x 53-1/2” – 54” on the lower bunk. The thickness of the mattress must not exceed 6” on the upper bunk.