Specifications

24
In-line Configuration
High Speed Programmable Actuator
Options
Mounting options: Front flange plate
Trunion
Side tapped holes
Foot mount
Rod ends: Universal rod end
1/2 – 20 Tapped hole
1/2 – 20 External threaded rod
Brake and Brake on motor
encoder: Encoder on motor
No brake or encoder
Encoder type: 400 line encoder
500 line encoder
Actuator Accessories
Sensors for end of stroke indication
Part Number
N.O. 840-9005 (for use with SS2000 control)
N.C. 840-9008 (for use with SS2000 control)
Programmable Motion Control
Indexer SS2000I
12 amp Drive SS2000D12
This high speed version of the Electrak 2000
actuator is designed to operate up to 45 inches
per second at no load. The load/speed chart
shows the actuator will also operate up to 5
inches per second with a 200 lb. load. This in-line
ball screw actuator is direct drive and available
with flange, foot, trunion and side tapped holes
for a variety of mounting options. The
combination of mounts with rod end options
provides either a very rigid connection for precise
applications or a compliant connection for
applications that require multiple degrees of
freedom. The SS2000I indexer and SS2000D12
drive provides the ability to program and operate
the actuator. It is an ideal replacement for air
cylinders in applications requiring variable speeds
and strokes.
Specifications
Dynamic Load: Up to 225 lb. at 5 in./sec.
Static Load: Up to 225 lb. without brake
option
Speed: Up to 45 in./sec. at no load
Acceleration: Up to 50 in./sec./sec. at no load
Duty Cycle: Continuous
Life: Up to 50 million cycles
End Play: 0.010 inch maximum
Resolution: 0.0005 based on 1/10 microstep
Limit Switches: Home limit switch standard,
other switches may be added on
two sides of the cover tube
Stroke Lengths: 2, 4, 6, 8, 12, 18, 24 inch
standard (for other lengths,
contact the factory)
Ambient Temperature: -40°F to 150°F (-40°C to 65°C)
Environment Protection: (IP42) standard (Dripping water)
(For washdown applications,
contact factory.)
Motor: MH112 Step motor
Brake: Due to the high efficiency of the
ball screw actuator, an
electrically released spring set
brake mounted on the motor will
be required to control back
driving or load holding.