Technical data

The features described in this illustration do not bind the manufacturer.
www.cavagnagroup.com
A 3
EDITION JUNE 2005
LPG VALVES & EQUIPMENT
DIVISION
67.0720
67.0.490.0720
APPLICATION
Multiservice valve suitable for ASME tanks where a vapor service valve is required.
This valve incorporates in the same body a service valve, a vapour withdrawal valve and a fixed level gauge.
FEATURES
Improved Stem Seal - Two seals - a back seat and an O-ring (both TFE coated) protect against stem leakage in the service valve portion.
When the service valve is fully open, the O-ring is not under pressure, increasing the service life of the O-ring.
Easy Seal Replacement - Should either of the stem seals need to be replaced, the tank does not have to be evacuated. Closing
the service valve and removing the handwheel and bonnet permits the O-ring and back seat to be reached.
Redesigned Body Configuration - Installation of the 67.0720 can be made with a standard 1” socket wrench using the large
center wrenching hex. The extremely low body silhouette (approximately 2 3/4”) allows the use of small, economical hoods.
Convenient Level Gauge - Top mounting of the fixed liquid level gauge gives easy access.
Gauge Connection - The 1/4” FNPT gauge connection can be plugged or left unplugged for installation of a pressure gauge.
Fixed level gauge - Please specify DT length when ordering
Everseal - Preapplied on the inlet thread
Various DT length upon request
Part number
Tank Vapor Service Vapor Line
Gauge Boss
Fixed Liquid Fixed Level Gauge Wrench
Connection Connection Connection Level Gauge DT length flat hex
67.0720 3/4" MNPT
Female POL
11/4" M Acme 1/4" FNPT Yes 12.00” 1”
CGA 510
ORDERING INFORMATION
Multiservice Valve