User Manual

11H
Optically Linear Square Law Inverse-Square Law S-Curve
Mode 1(Optically Linear): The increase in light intensity appears to be linear as DMX value is increased.
Mode 2(Square Law): Light intensity control is finer at low levels and coarser at high levels.
Mode 3(Inverse Square Law): Light intensity control is coarser at low levels and finger at high levels.
Mode 4(S-cure): Light intensity control is finger at low levels and high levels and coarser at medium
levels.
Dimmer Speed
Select the Dimmer Speed, press the ENTER button. Use the DOWN and UP button to select Fast or
Smooth. Once selected, press the ENTER button to setup or exit menu mode without any change after
30 seconds. Back to the functions without any change press the MENU button again.
White Balance
Select the White Balance, press the ENTER button to confirm. It can be adjusted with the whole fixture,
or it can be adjusted independently for each block.Use the UP and DOWN button to select
Red/Green/Blu/White, press the ENTER button to store, then use the UP and DOWN button to adjust
the value from (125~255), press the ENTER button to confirm. (DMX signal will be the first priority under
Manual Mode.) Once selected, press the ENTER button to store. Press the MENU button back to the last
menu without any change or idling 30 seconds to exit menu mode.
Language
Select the Language, press the ENTER button to confirm. Use the UP and DOWN button to adjust
English or Chinese .Once selected, press the ENTER button to store. Press the MENU button back to
the last menu without any change or idling 30 seconds to exit menu mode.