User Manual

13H
Fault report :
1、Fan.Error
Check that the fan is not running
Check the PCB board related detection circuit is damaged
2、Temp.Errot
Check that the test leads are in good contact and open
Check if the thermistor is broken
Check PCB board related circuit is damaged
Software Version
Sel
ect Software Version , press the ENTER button to confirm.
The display will show the ver
sion of
s
oftware of the unit
. Press
the MENU button back to the last menu or idling 30 seconds to exit menu
mode.
Sele
ct Factory Reset, press the ENTER button to confirm. Use the UP and DOWN button to adjust the
NO/Y
es
. Select Yes, fixture will resume factory settings. Press the MENU button back to the last menu or
idling 30 seconds to exit menu mode.
Facto
ry Rese
t
Error Logs
To select Error Logs, press the ENTER button to confirm. Use the UP/DOWN button to select Fixture
Errors or Reset Error Log, press the ENTER button to store. To select Reset Error Log, press the
ENTER button to confirm, use the UP/DOWN button to select No or Yes, press the ENTER button to
store. To select Yes, press the ENTER button to confirm, use the UP/DOWN button to set the
password 050, Press the MENU button to return to the previous menu or wait one minute to
automatically exit the menu mode.