Instruction Manual

Mounting the wall plate

to the wall

Brick, Solid Concrete and Concrete Block mounting:

Use the Wall Plate(a) as a template to mark 3 hole locations on the wall.

Make sure these holes are level. Pre-Drill these holes with a 3/8”(10mm)

masonry bit to at least 2.4”(60mm) in depth. Insert a Concrete Anchor(v)

into each of these holes.

Make sure the anchor is seated completely ush with the concrete

surface even if there is a layer of drywall or other material in front. Attach

the Wall Plate to the wall using 3pcs Lag Bolts(t) and 3pcs Lag Bolt

Washers(u), shown in Diagram 2A.

Wood Stud mounting:

The Wall Plate (a) must be mounted to two wood studs at least

16”(406mm) apart. Use a stud nder to locate two adjacent studs. It is a

good idea to verify where the studs are located with an awl or thin nail

shown in Diagram 2B. Pre-drill a 2.4”(60mm) deep hole at the desired

height in each stud using a 5/32”(4mm) drill bit. Make sure these holes

are in the center area of the studs and level with each other. Attach

the Wall Plate to the wall using the 2pcs Lag Bolts(t) and 2pcs Lag Bolt

Washers(u).

Diagram 2A Diagram 2B

Stud Finder

16 inch