Installation guide

102 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
ACLI COMMANDS N - Z SHOW
Values • IP address—Enter the IP address of the registrar whose
registration cache information you want to view. This value
can be wildcarded.
<by-route> Display information for calls by their Internet-routable IP
address. This allows you to view the endpoints associated with
public addresses.
Values • IP address—Enter the IP address whose registration cache
information you want to view. This value can be wildcarded.
<by-endpoint> Show registration information for a specific phone number or
username
Values • IP address—IP address of an endpoint, or a wildcarded IP
address value with an asterisk (*) at the end. This command is
only available if you configure the reg-via-key parameter in
the SIP interface configuration prior to endpoint registration.
The reg-via-key parameter keys all registered endpoints by IP
address and username.
• Phone number or username—Full phone number or
username, or a wildcarded number/username with an asterisk
(*)
The display shows statistics for the Period and Lifetime monitoring
spans.
–user Entries—The number of unique SIP Addresses of
Record in the cache
–Local Contacts—The number of contact entries in the cache
–Free Map Ports—The number of ports available in the free
signaling port pool
–Used Map Ports—The number of signaling ports allocated
for registration cache entries
–Forwards—Number of registration requests forwarded to
the real registrar
–Refreshes—Number of registrations the Net-Net SBC
answered without having to forward registrations to the real
registrar
–Rejects—Number of unsuccessful registrations sent to real
registrar
–Timeouts—Number of times a refresh from the HNT
endpoint was not received before the timeout
–Fwd Postponed—The number of times sipd responded out
of the cache instead of forwarding to the registrar due to the
max-register-forward threshold
–Fwd Rejected—The number of REGISTER 503s done after
checking for a cached entry
–Refr Extension—The number of times the max-register-
refresh threshold was exceeded. The "Active" and "High"
show the number of seconds added to the expiration