Installation guide
104 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
ACLI COMMANDS N - Z SHOW
show running-config
Syntax show running-config <configuration-element> <to-file>
The show running-config entered without any arguments displays the running
configuration information in use on the Net-Net SBC. If you use any configuration
element keyfield as an argument, this show command will display only that
specified configuration element.
Arguments <to-file> Send all output from the show config command to a specified
file located on the local flash file system instead of to the
ACLI. This is an optional argument.
<configuration-element> Specify the configuration element you want to view. This
is an optional argument. If you do not specify a configuration
element, the Net-Net SBC displays the entire configuration.
The following is a list of valid configuration elements:
Values • access-control—Show access-control configuration
• account-config—Show account-config configuration
• authentication—Show authentication configuration
• call-recording-server—Show call-recording-server
configurations
• certificate-record—Show certificate records configuration
• ext-policy-server—Show external-policy-server
configuration
• h323-config—Show h323-config configuration
• h323-stack—Show all h323-stack configurations
• enum-config—Shows enum-config configuration
• iwf-stack—Show iwf-stack configuration
• host-route—Show all host-route configurations
• local-policy—Show all local-policy configurations
• media-profile—Show all media-profile configurations
• media-manager—Show media-manager configuration
• mgcp-config—Show mgcp-config configuration
• dns-config—Show all dns-config configurations
• network-interface—Show all network-interface
configurations
• ntp-config—Show ntp-config configuration
• capture-receiver—Show capture-receiver configurations
• phys-interface—Show all phys-interface configurations
• realm—Show all realm configurations
• MediaPolicy—Show all MediaPolicy configurations