Installation guide

112 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
ACLI COMMANDS N - Z SHOW
• redundancy—Display sipd redundancy statistics. Executing
the show sipd redundancy command is the equivalent to the
show redundancy sipd command
• agents [hostname][method]—Display statistics related to
defined SIP session agents. Entering this command without
any arguments list all SIP session agents. By adding the IP
address or hostname of a session agent as well as a specified
method at the end of the command, you can display statistics
for that specific session agent and method. For a specific
session agent, identified by IP address, the show sipd agents
command lists:
–session agent state
• I—in-service
• O—out-of-service
• S—transitioning from out-of-service to in-service
• D—disabled
–inbound and outbound statistics
–average and maximum latency for each session agent
–maximum burst rate for each session agent as total number
of session invitations sent to or received from the session
agent within the amount of time configured in the burst-rate-
window field
Inbound Statistics:
–Active—Number of active sessions sent to each session
agent listed
–Rate—Average rate of session invitations (per second) sent
to each session agent listed
–ConEx—Number of times the constraints have been
exceeded
Outbound Statistics:
–Active—Number of active sessions sent from each session
agent
–Rate—Average rate of session invitations (per second) sent
from each session agent listed
–ConEx—Number of times the constraints have been
exceeded
Latency:
–Avg—Average latency for packets traveling to and from each
session agent
–Max—Maximum latency for packets traveling to and from
each session agent listed
• interface [interface-id][method]—Display SIP interface
statistics. By adding the optional interface-id and method