Installation guide

SHOW ACLI COMMANDS N - Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 115
–503 Service Unavail—Number of times server was unable to
handle the request due to a temporary overloading or
maintenance of the server
–5xx Server Error—Number of times the 5xx class of status
code appeared
–Response Retrsns—Number of response retransmissions
sent and received
–Transaction Timeouts— Number of times a transaction
timed out. The timer related to this transaction is Timer B, as
defined in RFC 3261
show sipd <message> output is divided in two sections:
Server and Client, with information for recent, total, and
period maximum time frames. This command also displays
information about the average and maximum latency. For
each type of SIP message, only those transactions for which
there are statistics are shown. If there is no data available for a
certain SIP message, the system displays the fact that there is
none and specifies the message about which you inquired.
• groups—Display cumulative information for all session
agent groups on the Net-Net SBC. This information is
compiled by totaling the session agent statistics for all of the
session agents that make up a particular session agent group.
While the show sipd groups command accesses the
subcommands that are described in this section, the main
show sipd groups command (when executed with no
arguments) displays a list of all session agent groups.
• groups -v—Display statistics for the session agents that
make up the session agent groups that are being reported. The
-v (meaning “verbose”) executed with this command must be
included to provide verbose detail.
• groups <specific group name>—Display statistics for the
specified session agent group
• endpoint-ip <phone number>—Displays registration
information for a designation endpoint entered in the <phone
number> argument; also show IMS-AKA data
• all—Display all the show sipd statistics listed above
• sip-endpoint-ip—See show sipd endpoint-ip
• sa-nsep-burst—Display NSEP burst rate for all SIP session
agents
• subscriptions-by-user—Display data for SIP per user
subscribe dialog limit
Example ACMEPACKET# show sipd errors