Installation guide

124 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
ACLI COMMANDS N - Z TEST-TRANSLATION
Example ACMEPACKET# test-policy time-of-day enabled
test-translation
The test-translation command is used to test translation rules configured for the
address translation feature. This command is also found in the session-router path.
Details on its use are found in the Configuration Elements N-Z chapter.
Syntax test-translation <argument>
Arguments <argument> The following is a list of test-translation arguments:
Values • called-address—Enter the address on which the called rules
are be applied. This entry is required.
• calling-address—Enter the address on which the calling
rules will be applied. This entry is required.
• show—Show results of translation
• translation-id—Enter translation rules to test
• exit—Exit the test translation
Mode User
Release First appearance: 1.3
Example ACMEPACKET# test-translation show
timezone-set
The timezone-set command sets the time zone and daylight savings time on the
Net-Net SBC.
Syntax timezone-set
Mode Superuser
Release First appearance: 1.0.
Notes The timezone-set command prompts the user for time zone, UTC offset, and
daylight saving time information. If daylight savings time for your time zone
changes start and stop dates yearly, this command must be set yearly.
Example ACMEPACKET# timezone-set
verify-config
The verify-config command verifies the Net-Net SBC’s current configuration.
Syntax verify-config