Installation guide

WATCHDOG ACLI COMMANDS N - Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 125
The verify-config command checks the consistency of configuration elements that
make up the current configuration and should be carried out prior to activating a
configuration on the Net-Net SBC.
Mode Superuser
Release First appearance: 1.3; Most recent update: S-C6.1.0
The verify-config command, entered either directly or via the save-config
command, checks for address duplication for a given network-interface within a
configuration. Addresses are checked for duplication based on the following criteria:
• Every address entered is checked against the Primary and Secondary Utility
addresses
• All UDP, TCP, and TFTP addresses are checked against other UDP, TCP, and
TFTP addresses respectively within the same port range
Notes For detailed information, refer to the Net-Net 4000 ACLI Maintenance and
Troubleshooting Guide.
Example ACMEPACKET# verify-config
watchdog
The watchdog command sets or queries the state of the watchdog timer. If the
system becomes unstable causing the watchdog timer to not reset, the system
reboots.
Syntax watchdog <arguments>
Arguments <arguments> The following is a list of valid arguments:
Values • enable—Enable the watchdog timer
• disable—Disable the watchdog timer
• fetch—Display the watchdog timer configuration
Mode User
Release First appearance: 2.0.1
Notes The fetch argument can be accessed from user mode.
Example ACMEPACKET# watchdog enable