Installation guide

Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 127
4 Configuration Elements A-M
access-control
The access-control configuration element is used to manually create ACLs for the
host path in the Net-Net SBC.
Syntax access-control <realm-id | description | source-address |
destination-address | application-protocol | transport-protocol |
access | average-rate-limit | trust-level | minimum-reserved-
bandwidth | invalid-signal-threshold | maximum-signal-threshold |
untrusted-signal-threshold | deny-period | nat-trust|threshold |
select | no | show | done | exit>
Parameters realm-id—Enter the ingress realm of traffic destined to host to apply this ACL
description—Provide a brief description of the access-control configuration
element
destination-address—Enter the destination address, net mask, port number, and
port mask to specify traffic matching for this ACL. Not specifying a port mask
implies an exact source port. Not specifying an address mask implies an exact IP
address. This parameter is entered in the following format:
<ip-address>[/<num-bits>][:<port>][/<port-bits>]
Default 0.0.0.0
source-address—Enter the source address, net mask, port number, and port mask
to specify traffic matching for this ACL. Not specifying a port mask implies an exact
source port. Not specifying an address mask implies an exact IP address. This
parameter is entered in the following format:
<ip-address>[/<num-bits>][:<port>][/<port-bits>]
Default 0.0.0.0
application-protocol—Select the application-layer protocol configured for this
ACL entry
Values • SIP
•MGCP
•NONE
transport-protocol—Select the transport-layer protocol configured for this ACL
entry
Default ALL
Values • ALL