Installation guide

ACCOUNT-CONFIG CONFIGURATION ELEMENTS A-M
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 129
untrusted-signal-threshold—Enter the maximum number of signaling messages
from untrusted sources allowed within the tolerance window
Default 0
Values Min: 0 / Max: 999999999
deny-period—Enter the time period in seconds a deny-listed or deny entry is
blocked by this ACL. The host is taken out of deny-list after this time period
elapses.
Default 30
Values Min: 0 / Max: 999999999
nat-trust-threshold—Enter maximum number of untrusted endpoints allowed
before an entire NAT device is demoted to untrusted. 0 means dynamic demotion of
NAT devices is disabled.
Default 0
Values Min: 0 / Max: 999999999
Path access-control is an element of the session-router path. The full path from the
topmost ACLI prompt is: configure terminal > session-router > access-control.
Release First appearance: 2.0 / Most recent update: 4.0
RTC Status Supported
Notes This is a multiple instance configuration element.
account-config
The account-config configuration element allows you to set the location where
accounting messages are sent.
Syntax account-config <hostname | port | strategy | state | max-msg-
delay | max-wait-failover | trans-at-close | generate-start |
generate-interim | file-output | file-path | max-file-size | max-
files | file-rotate-time | ftp-push | ftp-address | ftp-port |
ftp-user | ftp-password | ftp-remote-path | account-servers |
intermediate-period | cdr-output-redundancy | prevent-duplicate-
attrs | vsa-id-range | cdr-output-inclusive | file-rotate-time |
select | no | show | done | exit>
Parameters hostname—Enter the hostname of this Net-Net SBC; must be set to “localhost” or
the accounting configuration will not work properly. Entries are in FQDN format.
Default Localhost name
port—Enter the UDP port number from which RADIUS messages are sent
Default 1813
Values Min: 1025 / Max: 65535