Installation guide

AUTHENTICATION > RADIUS-SERVERS CONFIGURATION ELEMENTS A-M
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 135
authentication > radius-servers
The radius-servers subelement defines and configures the RADIUS servers that the
Net-Net SBC communicates with.
Syntax radius-servers <address | port | state | secret | nas-id | retry-
limit | retry-time | maximum-sessions | class | dead-time |
authentication-methods | select | no | show | done | exit>
Parameters address—Enter the IP address for the RADIUS server
port—Enter the port number on the remote IP address for the RADIUS server
Default 1812
Values 1645 | 1812
state—Enable or disable this configured RADIUS server
Default enabled
Values enabled | disabled
secret—Enter the password the RADIUS server and the Net-Net SBC share. This
password is not transmitted between the two when the request for authentication is
initiated.
nas-id—Enter the NAS ID for the RADIUS server
retry-limit—Set the number of times the Net-Net SBC retries to authenticate with
this RADIUS server
Default 3
Values Min: 1 / Max: 5
retry-time—Enter the time in seconds the Net-Net SBC waits before retrying to
authenticate with this RADIUS server
Default 5
Values Min: 5 / Max: 10
maximum-sessions—Enter the maximum number of sessions to maintain with
this RADIUS server
Default 255
Values Min: 1 / Max: 255
class—Select the class of this RADIUS server as either primary or secondary. A
connection to the primary server is tried before a connection to the secondary server
is tried.
Default primary
Values primary | secondary