Installation guide

CAPTURE-RECEIVER CONFIGURATION ELEMENTS A-M
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 139
capture-receiver
The capture-receiver configuration element allows you to configure packet tracing
functionality on your Net-Net SBC.
Syntax packet-trace-config <state | address | network-interface | select
| no | show | done | exit>
state—Enable or disable the Net-Net SBC’s TRACE capability
Default disabled
Values enabled | disabled
address—Enter the TRACE server IP address
network-interface—Enter the TRACE server outbound interface
Path packet-trace-config is an element of the system path. The full path from the
topmost ACLI prompt is: configure terminal > system > packet-trace-config.
Release First appearance: 5.0
RTC Status Supported
certificate-record
This configuration element configures certificate records for TLS support.
Syntax certificate-record <name | country | state | locality |
organization | unit | common-name | key-size | alternate-name |
trusted | key-usage-list | extended-key-usage-list | select | no
| show | done | exit>
name—Enter the name of the certificate record
country—Enter the name of the country
Default US
state—Enter the name of the state for the country
Default MA
locality—Enter the name of the locality for the state
Default Burlington
organization—Enter the name of the organization holding the certificate
Default Engineering
unit—Enter the name of the unit for holding the certificate within the organization
common-name—Enter the common name for the certificate record
key-size—Set the size of the key for the certificate