Installation guide

H323 CONFIGURATION ELEMENTS A-M
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 149
Values EMERGENCY | CRITICAL | MAJOR | MINOR | WARNING | NOTICE |
INFO | TRACE | DEBUG
response-tmo—Set the number of seconds Net-Net SBC waits between sending a
SETUP message and receiving no response before the call is torn down
Default 4
Values Min: 0 / Max: 999999999
connect-tmo—Set the number of seconds Net-Net SBC waits between sending
out a SETUP message and failing to receive a CONNECT message before the call is
torn down. If the Net-Net SBC receives a PROCEEDING or ALERT message from
the endpoint, it will tear down the session after this timer elapses if a CONNECT
message is not received.
Default 32
Values Min: 0 / Max: 999999999
options—Enter customer-specific features and/or parameters that affect H.323
behavior globally. This parameter sets a comma-separated list of “feature=value” or
“feature” parameters.
h323-stacks—Enter the h323-stacks subelement
rfc2833-payload—Enter the payload type used by the H.323 stack in preferred
rfc2833-mode
Default 101
Values Valid Range: 96-127
alternate-routing— Choose between pre-4.1 or 4.1 behavior:
• Pre-4.0 behavior—Alternate routing is disabled, and the Net-Net SBC sends
a release complete message back to the caller,
proxy
• 4.1 behavior—The Net-Net SBC performs alternate routing, recur
Default proxy
Values proxy | recur
codec-fallback—Enable or disable slow start to fast start codec negotiation
Default disabled
Values enabled | disabled
enum-sag-match—Enable or disable matching against the hostnames in
ENUM/LRT lookup responses and session agent groups
Default disabled
Values enabled | disabled
Path h323 is an element under the session-router path. The full path from the topmost
ACLI prompt is: configure terminal > session-router > h323.
Release First appearance: 1.2.1 / Most recent update: 4.1