Installation guide

H323 > H323-STACKS CONFIGURATION ELEMENTS A-M
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 151
h323 > h323-stacks
The h323-stack subelement supports the SFIWF, FSIWF, H.323<—>SIP traffic, and
general H.323 functionality.
Syntax h323-stacks <name | description | state | isgateway | realm-id |
assoc-stack | local-ip | max-calls | max-channels | registration-
ttl | terminal-alias | ras-port | auto-gk-discovery | multicast |
gatekeeper | gk-identifier | q931-port | alternate-transport |
q931-max-calls | h245-tunneling | fs-in-first-msg | call-start-
fast | call-start-slow | media-profiles | prefixes | process-
registration | allow-anonymous | options | proxy-mode | h245-
stage | q931-start-port | q931-number-ports | dynamic-start-port
| dynamic-number-ports | filename | tcp-keepalive | rfc2833-mode
| select | no | show | done | exit>
Parameters name—Enter the name of H.323 stack. This value is required and must be unique.
The value you enter in this parameter for your H.323 interface (stack) configuration
cannot start with a number; it must start with a letter. The Net-Net SBC considers
names that start with numbers to be invalid.
description—Provide a brief description of the h323-config configuration element
state—Enable or disable this h323-stack
Default enabled
Values enabled | disabled
Notes This parameter is not RTC supported.
isgateway—Enable or disable H.323 stack functionality as a Gateway. When this
field is set to enabled, the H.323 stack runs as a Gateway. When this field is set to
disabled, the H.323 stack runs as a Gatekeeper proxy.
Default enabled
Values enabled | disabled
Notes This parameter is not RTC supported.
realm-id—Enter the realm served by this H.323 stack. This value must be a valid
identifier for a realm configuration.
Notes This parameter is not RTC supported
assoc-stack—Enter the name of associated outbound H.323 stack for this h323-
stack instance. If not configured, the Net-Net SBC will use policy-based stack
selection based on a local policy (configured in a local-policy element). If you wish
to use static stack selection, then each configured h323-stack subelement must have
an associated outbound stack. This parameter must correspond to a valid name field
value in another instance of the h323-stack subelement.
Notes This parameter is not RTC supported.
local-ip—Enter the IP address H.323 stack uses when opening sockets. This field
value is the default H.323 stack address.